PROPERTIES
Easy to apply, good adhesion.
BASE / SURFACE PREPARATION Bonding surfaces must be hard, smooth, dry and clean. Before applying the adhesive the surface must be cleaned from dust, dirt, grease spots and other contaminants. Before applying the adhesive to mineral surfaces, we recommend to prime such surfaces using BRIKO base primer that will improve the adhesive's bond with the base and prevent the adhesive from drying too quickly. If there are any cracks on the surface, use acrylic sealant or other material to seal them before applying the adhesive.
MIXTURE PREPARATION
The adhesive is ready to use. Mix well before use!
CONSUMPTION AND OUTPUT
0.3-0.35 kg/m ² (depending on the type of surface and spatula used)
STORAGE CONDITIONS
Store in a tightly closed container at a temperature of at least + 4 °C. Prevent from freezing!
SHELF LIFE Best for 12 months after the date of production.
ATTENTION! WORK SAFETY
Keep out of reach of children. After contact with eyes, wash immediately with plenty of water and seek medical advice. After contact with skin, wash immediately with plenty of water and soap.
Only apply the adhesive to a concrete surface after concrete has dried completely; allowable humidity – 4% or lower. The adhesive can be applied using several types of spatulas (we recommend A1, A2 or A3). Environmental parameters (temperature and humidity) affect the adhesive curing time. Open holding time should not exceed 15 minutes; therefore, flooring or coating should be pressed against the surface within this time. When the coating is characterized by high internal stresses and tends to curl, pressing against with weight for 24 hours recommended. Recommended room temperature +18. Before bonding, leave the coating the in the room to adapt to room conditions. Do not use the adhesive when the ambient and wallpaper temperature is below +15 °C. Contaminated tools and containers may be cleaned using warm water and detergent.
