PROPERTIES
The adhesive is resistant to cold, heat (from - 15 °C to + 70 °C) and moisture. Very good bond with vertical surfaces. Longer adhesiveness, suitable for heat-insulated floors.
SURFACE PREPARATION
The base must be clean, firm, solid, free from dust, lime, fat, and old paint residue. Use base primer for surfaces with high moisture absorption capacities. Use primer with quartz sand for old tiles.
MIXTURE PREPARATION
Pour the contents of the package (25 kg) into 6 to 7 litres of clean room temperature water. Mix manually or mechanically until homogeneous until homogeneous. Leave for 10 minutes, then stir again. This adhesive mixture can be used for about an hour, depending on the ambient temperature.
CONSUMPTION AND OUTPUT
The output is 2-4 kg/m2 (depending on the size of spreader's notches and roughness of the surface).
STORAGE CONDITIONS
Store the product in a secure, dry place and keep the product dry..
SHELF LIFE
12 months from the date of production.
ATTENTION! WORK SAFETY
The work must be carried out in a dry environment. During work and two days after tiling, air and base temperature must be between + +5 °C and + 30 °C. All data and recommendations provided are valid at a temperature of + 20 °C and relative humidity of 60%. Under other conditions the adhesive properties may change. Provided work recommendations are observed, the producer ensures the quality of the adhesive. However, the producer will not be responsible for any consequences that may result from use of the adhesive in other conditions, or for other purposes.
Use a flat spreader to apply a thin layer of adhesive to prepared surface. After that, apply a thicker layer of adhesive and use a notched spreader to smooth the area that should be tiled within 30 minutes. Firmly press tiles into the layer of adhesive with rotary or slip motion, then put them into place immediately. Attached tiles must not be connected or come into contact with each other. The tile position can be adjusted within 20 minutes after attachment. Gaps between wall tiles must be filled no less than 24 hours after tiling. After 2 days you will be able to carefully walk on the floor without causing damage to it. Full durability and resistance to water will be achieved after 28 days. Choose a proper notched spreader. Notch size should be 6x6 mm, distance between the centres of notches should be 12 mm. For larger tiles, use spreader For larger tiles, use spreader with larger notches. After having completed the work, wash used tools with water.
