PACKAGE
1 kg, 5 kg, 10 kg.
PASKIRTIS
Used to attach parquet flooring (block or inlaid) and floorboards to concrete, cement, wood, particle board, fibreboard, and similar surfaces.
PROPERTIES
Easy to apply, waterproof dispersion adhesive high in non-volatile components. High content of non-volatile matter and low content of water in the adhesive ensures rapid bonding. Does not contain organic solvents.
BASE / SURFACE PREPARATION
Surfaces must be dry, smooth, stable, securely attached, hard, and clean. Before applying the adhesive the surface must be cleaned from dust, dirt, grease spots and other contaminants. If the surface is very tarred, before gluing the resin should be removed using solvent. Before applying on mineral or highly absorbent and uneven surfaces, priming is recommended.
MIXTURE PREPARATION
The adhesive is ready to use. Mix well before use.
CONSUMPTION AND OUTPUT
0.33-0.67 kg/m².
STORAGE CONDITIONS
Store in a tightly closed container at a temperature of at least + 4 °C. Prevent from freezing!
SHELF LIFE Best for 12 months after the date of production.
ATTENTION! WORK SAFETY
Keep out of reach of children. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. After contact with skin, wash immediately with plenty of water and soap.
The adhesive can be applied manually (using different types of spatulas and fastening tools) or simply squeezed out of the bottle using special adhesive stopper. The room's relative humidity must not exceed 60 %. If applied on concrete, it's moisture content must not exceed 3 %, while when used on subfloor, chipboard, OSB, etc., the moisture content thereof must not exceed 12 %. For the parquet to match the conditions of the premises in which it will be laid, it must be stored in the respective premises for a certain period of time. To ensure strong bonding, apply a layer of adhesive to each side. Compression duration depends on operating conditions. Environmental parameters (temperature and humidity) affect the adhesive curing time. At higher temperatures and lower humidity, the adhesive dries more quickly. Open holding time should not exceed 15 minutes; therefore, within this time you should apply the adhesive and press boards or panels against the surface. Do not use the adhesive when the ambient and wallpaper temperature is below +10 °C. Contaminated tools and containers may be cleaned using warm water and detergent.
